甲硫氨酸對銅合金在NaCl溶液中的緩蝕性能研究
發布時間：2019-06-19 18:06
【摘要】：銅鎳合金具有良好的耐蝕性,廣泛應用于各種海洋工業部門。但長時間在海水的侵蝕下,合金還是會發生嚴重的腐蝕。向介質中添加緩蝕劑是防止金屬腐蝕的一種簡單高效的方法。然而大多數傳統緩蝕劑都是環境有害的。氨基酸作為一種環境友好型緩蝕劑,曾被用作抑制鋼,鋁等金屬腐蝕。本文選取了含硫原子的一種氨基酸(甲硫氨酸),作為Cu-10 wt.%Ni合金在3.5 wt.%Na Cl溶液的緩蝕劑。采用電化學阻抗譜,動電位極化曲線,循環伏安法研究了所選緩蝕劑的緩蝕行為,通過傅里葉變換紅外光譜和掃描電子顯微鏡分析了試樣表面成分及形貌,研究其作用機理。為了提高其緩蝕效率,選擇硅酸鈉和磷酸鈉兩種無機緩蝕劑與之復配,探討協同效果及作用機理。主要的研究成果如下:(1)單獨添加甲硫氨酸對Cu-10 wt.%Ni合金在3.5 wt.%Na Cl溶液具有一定的緩蝕效果。在濃度為40 ppm時緩蝕效率達到最大,為60%。屬于陰極型緩蝕劑,通過抑制陰極吸氧反應來控制整體的腐蝕過程。對浸泡后的表面膜層進行SEM分析,可以發現,表面形成膜層,但較疏松,只能一定程度上抑制氯離子的侵襲。(2)在3.5 wt.%Na Cl溶液同時添加甲硫氨酸和硅酸鈉對Cu-10 wt.%Ni合金的緩蝕具有協同作用。添加20 ppm甲硫氨酸與20 ppm硅酸鈉復配,緩蝕效率達到90%。復配緩蝕劑仍屬于陰極型緩蝕劑。協同效果是由于兩種緩蝕劑分子相互作用,在合金表面生成了平整,致密的膜層,能夠有效的抵御氯離子的侵襲。(3)在3.5 wt.%Na Cl溶液中同時添加甲硫氨酸和磷酸鈉對Cu-10wt.%Ni合金的緩蝕行為具有良好的協同作用。當添加40 ppm甲硫氨酸與200 ppm磷酸鈉復配,緩蝕效率達到最大,為98%,大于兩種緩蝕劑單獨使用時的緩蝕效率。復配緩蝕劑屬于混合型緩蝕劑,既能抑制陽極反應,又能抑制陰極吸氧反應。SEM結果表明,同時添加兩種緩蝕劑,能夠形成多種遮蔽性化合物,綜合兩種膜層的優勢,使之相互配合,形成了致密又較厚的膜層,從而發揮協同效果。
[Abstract]:Copper-nickel alloy has good corrosion resistance and is widely used in various marine industries. However, under the erosion of seawater for a long time, the alloy will still have serious corrosion. Adding corrosion inhibitor to medium is a simple and efficient method to prevent metal corrosion. However, most traditional corrosion inhibitors are harmful to the environment. Amino acids, as an environmentally friendly corrosion inhibitor, have been used to inhibit corrosion of steel, aluminum and other metals. In this paper, an amino acid containing sulfur atom (methionine) was selected as corrosion inhibitor for Cu-10 wt.%Ni alloy in 3.5 wt.%Na Cl solution. The corrosion inhibition behavior of the selected corrosion inhibitor was studied by electrochemical impedance spectroscopy, potentiodynamic polarization curve and cyclic volt-ampere method. The surface composition and morphology of the sample were analyzed by Fourier transform infrared spectroscopy and scanning electron microscope, and the mechanism of action was studied. In order to improve the corrosion inhibition efficiency, sodium silicate and sodium phosphate were selected to combine them, and the synergistic effect and mechanism were discussed. The main results are as follows: (1) the addition of methionine alone has a certain corrosion inhibition effect on Cu-10 wt.%Ni alloy in 3.5 wt.%Na Cl solution. When the concentration is 40 ppm, the corrosion inhibition efficiency reaches the maximum, which is 60%. It belongs to cathode corrosion inhibitor, which controls the whole corrosion process by inhibiting cathodic oxygen absorption reaction. SEM analysis of the immersed surface film showed that the film was formed on the surface, but it was loose and could only inhibit the invasion of chloride ion to a certain extent. (2) the addition of methionine and sodium silicate at the same time in 3.5 wt.%Na Cl solution had synergistic effect on the corrosion inhibition of Cu-10 wt.%Ni alloy. The corrosion inhibition efficiency was 90% when 20 ppm methionine was added with 20 ppm sodium silicate. The compound corrosion inhibitor still belongs to cathode corrosion inhibitor. The synergistic effect is that a flat and dense film is formed on the surface of the alloy due to the interaction of the two inhibitor molecules, which can effectively resist the invasion of chloride ions. (3) the addition of methionine and sodium phosphate to 3.5 wt.%Na Cl solution has a good synergistic effect on the corrosion inhibition behavior of Cu-10wt.%Ni alloy. When 40 ppm methionine and 200 ppm sodium phosphate were added, the corrosion inhibition efficiency reached the maximum (98%), which was higher than that when the two inhibitors were used alone. The composite corrosion inhibitor is a mixed corrosion inhibitor, which can not only inhibit the anodic reaction, but also inhibit the cathodic oxygen absorption reaction. The SEM results show that the addition of two corrosion inhibitors at the same time can form a variety of concealment compounds, synthesize the advantages of the two films, make them cooperate with each other, and form a dense and thick film, thus giving full play to the synergistic effect.
【學位授予單位】：太原理工大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TG174.42
本文編號：2502545
[Abstract]:Copper-nickel alloy has good corrosion resistance and is widely used in various marine industries. However, under the erosion of seawater for a long time, the alloy will still have serious corrosion. Adding corrosion inhibitor to medium is a simple and efficient method to prevent metal corrosion. However, most traditional corrosion inhibitors are harmful to the environment. Amino acids, as an environmentally friendly corrosion inhibitor, have been used to inhibit corrosion of steel, aluminum and other metals. In this paper, an amino acid containing sulfur atom (methionine) was selected as corrosion inhibitor for Cu-10 wt.%Ni alloy in 3.5 wt.%Na Cl solution. The corrosion inhibition behavior of the selected corrosion inhibitor was studied by electrochemical impedance spectroscopy, potentiodynamic polarization curve and cyclic volt-ampere method. The surface composition and morphology of the sample were analyzed by Fourier transform infrared spectroscopy and scanning electron microscope, and the mechanism of action was studied. In order to improve the corrosion inhibition efficiency, sodium silicate and sodium phosphate were selected to combine them, and the synergistic effect and mechanism were discussed. The main results are as follows: (1) the addition of methionine alone has a certain corrosion inhibition effect on Cu-10 wt.%Ni alloy in 3.5 wt.%Na Cl solution. When the concentration is 40 ppm, the corrosion inhibition efficiency reaches the maximum, which is 60%. It belongs to cathode corrosion inhibitor, which controls the whole corrosion process by inhibiting cathodic oxygen absorption reaction. SEM analysis of the immersed surface film showed that the film was formed on the surface, but it was loose and could only inhibit the invasion of chloride ion to a certain extent. (2) the addition of methionine and sodium silicate at the same time in 3.5 wt.%Na Cl solution had synergistic effect on the corrosion inhibition of Cu-10 wt.%Ni alloy. The corrosion inhibition efficiency was 90% when 20 ppm methionine was added with 20 ppm sodium silicate. The compound corrosion inhibitor still belongs to cathode corrosion inhibitor. The synergistic effect is that a flat and dense film is formed on the surface of the alloy due to the interaction of the two inhibitor molecules, which can effectively resist the invasion of chloride ions. (3) the addition of methionine and sodium phosphate to 3.5 wt.%Na Cl solution has a good synergistic effect on the corrosion inhibition behavior of Cu-10wt.%Ni alloy. When 40 ppm methionine and 200 ppm sodium phosphate were added, the corrosion inhibition efficiency reached the maximum (98%), which was higher than that when the two inhibitors were used alone. The composite corrosion inhibitor is a mixed corrosion inhibitor, which can not only inhibit the anodic reaction, but also inhibit the cathodic oxygen absorption reaction. The SEM results show that the addition of two corrosion inhibitors at the same time can form a variety of concealment compounds, synthesize the advantages of the two films, make them cooperate with each other, and form a dense and thick film, thus giving full play to the synergistic effect.
【學位授予單位】：太原理工大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TG174.42
【參考文獻】
相關期刊論文 前10條
1 呂江維;曲有鵬;田家宇;馮玉杰;劉峻峰;;循環伏安法測定電極電催化活性的實驗設計[J];實驗室研究與探索;2015年11期
2 周娜;侯利鋒;衛英慧;郭春麗;杜華云;;磷酸鈉在NaCl溶液中對AZ31鎂合金的緩蝕作用[J];稀有金屬材料與工程;2015年09期
3 程偉;周揚;古華山;陸秀群;蔣金玉;;環境友好型緩蝕劑的研究進展[J];石油化工腐蝕與防護;2015年03期
4 介鄧飛;泮進明;應義斌;;規�；笄蒺B(yǎng)殖污染氣體現場檢測方法與儀器研究進展[J];農業工程學報;2015年01期
5 劉金華;姜峨;龔賓;馬韋剛;溫菊花;王春;;甲基苯駢三氮唑和磷酸鈉對銅及不銹鋼的緩蝕性能研究[J];原子能科學技術;2013年12期
6 黃紹錦;;白銅質古錢幣的收藏與鑒賞[J];收藏界;2012年06期
7 吳鋒景;張勝濤;陶志華;;鞣酸鈉對氯化鈉溶液中AZ61鎂合金的緩蝕作用[J];材料保護;2010年12期
8 李瑾;張大全;;緩蝕膜自組裝技術的研究與發展[J];腐蝕與防護;2010年03期
9 沈大媧;馬清林;;硅酸鹽緩蝕劑的研究及其在鐵質文物保護中的應用[J];腐蝕科學與防護技術;2009年06期
10 王國瑞;劉崢;劉二喜;劉寶玉;;綠色緩蝕劑研究現狀與展望[J];腐蝕與防護;2009年10期
相關會議論文 前1條
1 時士峰;丁斯婧;徐群杰;;復配聚環氧琥珀酸和鎢酸鈉對白銅B30在模擬冷卻水中的緩蝕性能研究[A];2010年全國腐蝕電化學及測試方法學術會議摘要集[C];2010年
相關碩士學位論文 前2條
1 周娜;NaCl溶液中AZ31鎂合金緩蝕劑的研究[D];太原理工大學;2014年
2 成艷芳;銅及其合金的抗變色劑研究[D];揚州大學;2014年
，本文編號：2502545
本文鏈接：http://www.lk138.cn/shoufeilunwen/boshibiyelunwen/2502545.html
最近更新
教材專著
