發布時間：2018-04-18 05:01

  本文選題：射頻 + 收發機��； 參考：《電子科技大學》2014年碩士論文

【摘要】：現如今,射頻技術有著廣泛的應用市場。不論是在民用方面還是在軍用方面,射頻技術都不斷深化著無線通信技術的革新,不斷促進著人類的移動通信方式。射頻收發機作為無線通信技術中的重要一環很大程度上直接決定了無線通信系統的質量。射頻收發模塊不僅要滿足發射信號頻譜純凈、接收靈敏度高抗干擾能力強、發射機效率高動態范圍大等要求外,還要求射頻收發模塊滿足體積小、輕便、較低的驅動電壓、功耗小等一系列要求。本課題在于設計一款A(yù)M調制雙發射通道、ASK/OOK調制單接收通道的射頻收發機,收發工作頻段700~1100MHz,發射通道發射頻率分辨率高,發射功率動態范圍大且控制精度高,接收頻帶寬,噪聲系數小。兩條發射通路設計相同,發射頻率功率單獨可控,可以單獨工作也可以同時工作,收發機由于收發功能在不同的通道內實現,因此可以實現全雙工工作,具有一定的應用價值。本論文以收發機頻率源及收發鏈路作為本論文的主要研究?jī)?nèi)容,通過研讀許多國內外射頻收發機和相關電路論文文獻基礎上,從理論上分析了收發機的幾種基本結構和相關理論并結合頻率合成技術、調制解調技術、混頻技術、功率放大技術、自動增益控制原理、濾波器技術等相關電路設計理論與應用討論了收發機系統的實現。通過對收發機基本結構的對比,提出了本課題的系統方案和相關電路設計思想,同時通過ADS(Advanced Design System)仿真軟件,從系統鏈路和相關電路兩個層面對收發系統進行了全面的設計與仿真,通過對結構和參數的優化仿真得出了滿足要求的射頻收發系統、驗證了方案的設計。最后,通過Altium Designer PCB設計軟件進行了實際電路的設計,并對電路實物進行了調試與測試,分析了調試測試過程中出現的問題,提出了解決方案,得到滿足性能要求的收發系統整機。
[Abstract]:Nowadays, RF technology has a wide application market.In both civil and military fields, radio frequency technology is deepening the innovation of wireless communication technology and promoting human mobile communication mode.Radio frequency transceiver, as an important part of wireless communication technology, directly determines the quality of wireless communication system.RF transceiver module should not only meet the requirements of pure spectrum of transmitting signal, strong anti-interference ability of receiving sensitivity, high dynamic range of transmitter efficiency and so on, but also require RF transceiver module to meet the requirements of small volume, light and low driving voltage.Low power consumption and a series of requirements.This subject is to design a radio frequency transceiver with AM modulation dual transmitting channel / ASK / OOK modulation single receiving channel. The transmitter has high frequency resolution of transmitting frequency, high dynamic range of transmission power and high control precision, and has high receiving frequency bandwidth.The noise coefficient is small.The design of the two transmission paths is the same, the transmission frequency power can be controlled separately, and the transceiver can work either alone or at the same time. Because the transceiver functions are realized in different channels, the transceiver can realize full duplex operation, which has certain application value.This thesis takes transceiver frequency source and transceiver link as the main research content of this paper, through reading many domestic and foreign RF transceiver and related circuit paper literature foundation.Several basic structures and related theories of transceiver are analyzed theoretically and combined with frequency synthesis technology, modulation and demodulation technology, mixing technology, power amplifier technology, automatic gain control principle.The realization of transceiver system is discussed in this paper.By comparing the basic structure of transceiver, the system scheme and related circuit design idea of this subject are put forward, and the simulation software of ADS(Advanced Design system is used.The transceiver system is designed and simulated from two aspects of system link and related circuit. The RF transceiver system which meets the requirements is obtained by optimizing the structure and parameters, and the design of the scheme is verified.Finally, the actual circuit is designed by Altium Designer PCB, and the circuit is debugged and tested. The problems in debugging and testing are analyzed, and the solution is put forward.Get the whole transceiver system to meet the performance requirements.
【學位授予單位】：電子科技大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TN859

【參考文獻】

相關碩士學位論文 前1條

1 李占國;8～18GHz寬帶微波頻率源模塊研究[D];電子科技大學;2010年

，

本文編號：1766885