發布時間：2018-05-18 11:39

  本文選題：高溫高鹽油藏 + 就地聚合凝膠�。� 參考：《西南石油大學》2015年碩士論文

【摘要】：本文以高溫高鹽油藏為研究對象,開展相應堵水技術的研究,主要完成了以下內容并取得了相應的成果,克服了組分較多、成膠時間太短及穩定性較差等缺陷。 (1)根據高溫高鹽油藏的特點與要求,研制出了一種組分少、易泵入、成膠時間可調、成膠強度高、封堵能力強、耐溫耐鹽和耐沖刷的就地聚合凝膠堵水劑,并確定了堵水劑體系的最佳組成。 (2)通過對堵水劑進行室內靜態評價,確定了堵水劑適應的pH值范圍,并考察了溫度及礦化度對堵水劑成膠性能的影響。①堵水劑體系在pH值5.0-9.0之間強度和長期穩定性都較好；②堵水劑體系在礦化度為25×104mg/L模擬地層水中,90天內能夠保持較高強度；③堵水劑體系在高溫120℃條件下,具有良好的長期熱穩定性,90d后強度依然很高。 (3)進行了巖心物理模擬實驗。①單巖心流動實驗結果表明,堵水劑具有良好的注入性,對不同滲透率地層都具有較強的封堵能力,封堵率均大于98%；②封堵后的巖心經過30PV注入水沖刷后,巖心的封堵率減小幅度不大,封堵率仍大于97%,具有良好的耐沖刷能力；③雙并聯巖心實驗結果表明,堵水劑具有良好的選擇封堵性,能優先進入高滲層,對高滲層的封堵率大于98%。 本文的研究成果為高溫高鹽油藏的堵水提供了理論依據和技術儲備,具有一定指導意義和實際應用價值。
[Abstract]:In this paper, the research on high temperature and high salt reservoir is used to carry out the research of water plugging technology. The following contents are completed and the corresponding results have been achieved, which overcomes the defects of more components, short gelation time and poor stability.
(1) according to the characteristics and requirements of high temperature and high salt reservoir, a kind of local polymerizing gel plugging agent with low composition, easy pumping, adjustable glue time, high adhesive strength, strong plugging ability, temperature resistance, salt resistance and erosion resistance is developed, and the best composition of the water plugging agent system is determined.
(2) through the static evaluation of water plugging agent, the pH value range of water plugging agent was determined and the effect of temperature and salinity on the properties of plugging agent was investigated. (1) the water plugging agent system was better between the pH value 5.0-9.0 and the long-term stability; 2. The water plugging agent system was in the 25 x 104mg/L simulated formation water and 90 days internal energy. The water plugging agent system has good long-term thermal stability at high temperature of 120 C, and its strength is still very high after 90d.
(3) the core physical simulation experiment was carried out. (1) the experimental results of single core flow show that the plugging agent has good injectivity and has strong blocking ability to different permeability formations, and the blocking rate is more than 98%. After the core has been washed by 30PV injecting water, the blocking rate of core is less than 97%, and the blocking rate is still greater than 97%. The results of double parallel core test show that the water plugging agent has good selection and plugging ability, and it can enter high permeability layer with high permeability, and the sealing rate of high permeability layer is greater than 98%.
The research results in this paper provide theoretical basis and technical reserve for water plugging in high temperature and high salinity reservoirs, which has certain guiding significance and practical application value.
【學位授予單位】：西南石油大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TE358.3

【參考文獻】

相關期刊論文 前10條

1 唐孝芬,蔡志軍,張繼勇;地層內聚合丙烯酰胺凝膠堵水封竄技術[J];石油勘探與開發;1997年03期

2 王鑒,趙福麟;高價金屬離子與聚丙烯酰胺的交聯機理[J];石油大學學報(自然科學版);1992年03期

3 才程,趙福麟;鉻凍膠堵劑突破壓力的測定[J];石油大學學報(自然科學版);2002年05期

4 周明;趙金洲;蒲萬芬;楊燕;;一種新型抗溫抗鹽超強堵劑的研制[J];中國石油大學學報(自然科學版);2010年03期

5 史鳳琴;國內外油田化學堵水劑[J];石油鉆采工藝;1992年05期

6 陳淵;陳旭;;納米堵劑在油田超深疑難井封堵上的應用研究[J];石油鉆探技術;2007年06期

7 李宇鄉;;TP-910調剖技術研究[J];石油鉆采工藝;1988年07期

8 張明水;楊展榮;;聚丙烯酰胺—烏洛托品—間苯二酚堵水技術[J];石油鉆采工藝;1988年07期

9 雷鑫宇;李卉;陳爽;李文濤;齊志剛;陳大鈞;;聚乙烯醇-脲醛樹脂堵水劑的改性研究[J];應用化工;2014年02期

10 高為禮;;部分水解聚丙烯腈堵水技術[J];石油鉆采工藝;1988年07期

，

本文編號：1905691