基于改進CORDIC算法的直接數字頻率合成器研究
發布時間：2019-05-18 03:22
【摘要】：直接數字頻率合成器簡稱為DDS,這是一種最近一些年才發展起來的新型的頻率合成技術。這種技術依托于快速發展的集成電路技術,現代集成電路技術根據摩爾定律的預測在不斷的進步,直接數字頻率合成器在這個環境之下也受到越來越多的重視。這種頻率合成技術比以前的傳統頻率合成技術分辨率更高,轉換時間更快,噪聲更低,所以在許多的電子系統當中被廣泛的應用。相位累加器、相幅轉換器、數模轉換器和低通濾波器這幾個部分構成了直接數字頻率合成器。以前的直接數字頻率合成器一般都是采用查找表ROM或者CORDIC算法來實現相幅轉換器,這兩種方法各有優點,現在一般采用的是CORDIC算法實現,這種方法電路比較簡單,占用的存儲容量也很小。本文提出的直接數字頻率合成器使用的是查找表ROM和CORDIC算法結合使用,能夠減小噪聲、減小轉換時間、提高SFDR。同時這種方法能夠減少計算迭代的次數,從而減少硬件電路的資源消耗。本文采用相位累加器的位寬是32位,相位累加器輸出截?cái)嘀笫?9位,高3位用來進行區塊選擇,接下來的7位用來進行查找表ROM尋址,低9位用于CORDIC算法的旋轉計算。RTL級的代碼實現進行仿真時,SFDR均能夠達到113dB左右,有比較高的無雜散動態范圍。本文的DDS有三種工作模式:斜坡模式,Profile模式和單頻模式。本篇文章對直接數字合成器的許多方面進行了詳細的介紹,包括其概念、國內外的發展?fàn)顩r、其基本的結構原理。然后是本文的主要工作點,也就是相位幅度轉換器的改進。最后對本文提出的DDS進行了邏輯綜合和后端物理設計。進行邏輯綜合的時候采用的工藝庫是中芯國際的SMIC 0.18μm 1.8V 1P6M CMOS庫,邏輯綜合之后的芯片單元的總數是36700個,31074個組合邏輯單元,5623個時序邏輯單元,6306063.20μm2的總面積。1235.3mW的動態功耗和465.65μW的靜態功耗,總的功耗是1235.8mW。
[Abstract]:Direct digital frequency synthesizer (DDS,) is a new frequency synthesis technology which has only been developed in recent years. This technology relies on the rapid development of integrated circuit technology. According to Moore's law, modern integrated circuit technology is making continuous progress, and direct digital frequency synthesizer has been paid more and more attention in this environment. Compared with the previous traditional frequency synthesis technology, this frequency synthesis technology has higher resolution, faster conversion time and lower noise, so it is widely used in many electronic systems. Phase accumulator, phase amplitude converter, digital-to-analog converter and low-pass filter constitute direct digital frequency synthesizer. In the past, the direct digital frequency synthesizer generally used the look-up table ROM or CORDIC algorithm to realize the phase amplitude converter. These two methods have their own advantages. Now the direct digital frequency synthesizer is usually implemented by CORDIC algorithm. This method circuit is relatively simple. The storage capacity occupied is also very small. The direct digital frequency synthesizer proposed in this paper uses the combination of look-up table ROM and CORDIC algorithm, which can reduce noise, reduce conversion time and improve SFDR.. At the same time, this method can reduce the number of iterations, thus reducing the resource consumption of hardware circuits. In this paper, the bit width of the phase accumulator is 32 bits, the output of the phase accumulator is 19 bits, the high 3 bits are used for block selection, and the next 7 bits are used for ROM addressing of the lookup table. The low 9 bits are used in the rotation calculation of CORDIC algorithm. When the code implementation at RTL level is simulated, the SFDR can reach about 113dB, and has a high non-stray dynamic range. There are three working modes of DDS in this paper: slope mode, Profile mode and single frequency mode. In this paper, many aspects of direct digital synthesizer are introduced in detail, including its concept, development at home and abroad, and its basic structure and principle. Then there is the main working point of this paper, that is, the improvement of phase amplitude converter. Finally, the logic synthesis and back-end physical design of DDS proposed in this paper are carried out. The process library used in logic synthesis is SMIC 0.18 渭 m 1.8V 1P6M CMOS library. The total number of chip units after logic synthesis is 36700, 31074 combinational logic units and 5623 sequential logic units. The total area of 6306063.20 渭 m ~ 2. 1235.3 mW dynamic power consumption and 465.65 渭 W static power consumption, the total power consumption is 1235.8 MW.
【學位授予單位】：西安電子科技大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TN741
本文編號：2479630
[Abstract]:Direct digital frequency synthesizer (DDS,) is a new frequency synthesis technology which has only been developed in recent years. This technology relies on the rapid development of integrated circuit technology. According to Moore's law, modern integrated circuit technology is making continuous progress, and direct digital frequency synthesizer has been paid more and more attention in this environment. Compared with the previous traditional frequency synthesis technology, this frequency synthesis technology has higher resolution, faster conversion time and lower noise, so it is widely used in many electronic systems. Phase accumulator, phase amplitude converter, digital-to-analog converter and low-pass filter constitute direct digital frequency synthesizer. In the past, the direct digital frequency synthesizer generally used the look-up table ROM or CORDIC algorithm to realize the phase amplitude converter. These two methods have their own advantages. Now the direct digital frequency synthesizer is usually implemented by CORDIC algorithm. This method circuit is relatively simple. The storage capacity occupied is also very small. The direct digital frequency synthesizer proposed in this paper uses the combination of look-up table ROM and CORDIC algorithm, which can reduce noise, reduce conversion time and improve SFDR.. At the same time, this method can reduce the number of iterations, thus reducing the resource consumption of hardware circuits. In this paper, the bit width of the phase accumulator is 32 bits, the output of the phase accumulator is 19 bits, the high 3 bits are used for block selection, and the next 7 bits are used for ROM addressing of the lookup table. The low 9 bits are used in the rotation calculation of CORDIC algorithm. When the code implementation at RTL level is simulated, the SFDR can reach about 113dB, and has a high non-stray dynamic range. There are three working modes of DDS in this paper: slope mode, Profile mode and single frequency mode. In this paper, many aspects of direct digital synthesizer are introduced in detail, including its concept, development at home and abroad, and its basic structure and principle. Then there is the main working point of this paper, that is, the improvement of phase amplitude converter. Finally, the logic synthesis and back-end physical design of DDS proposed in this paper are carried out. The process library used in logic synthesis is SMIC 0.18 渭 m 1.8V 1P6M CMOS library. The total number of chip units after logic synthesis is 36700, 31074 combinational logic units and 5623 sequential logic units. The total area of 6306063.20 渭 m ~ 2. 1235.3 mW dynamic power consumption and 465.65 渭 W static power consumption, the total power consumption is 1235.8 MW.
【學位授予單位】：西安電子科技大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TN741
【參考文獻】
相關期刊論文 前3條
1 劉馬良;朱樟明;郭旭龍;楊銀堂;;一種4路內插CORDIC的14位吉赫茲DDS IP核[J];西安電子科技大學學報;2013年06期
2 陳雙燕;賴松林;楊尊先;程樹英;;一種電子系統認證芯片的電源規劃[J];現代電子技術;2011年06期
3 李素梅;張靜;;DDS幾種主要相位——幅度轉換方法[J];電腦知識與技術;2009年12期
相關博士學位論文 前2條
1 石雄;直接數字頻率合成技術的研究與應用[D];華中科技大學;2007年
2 于寶東;用于物理綜合的布線估計算法[D];華中科技大學;2006年
，本文編號：2479630
本文鏈接：http://www.lk138.cn/kejilunwen/dianzigongchenglunwen/2479630.html
最近更新
教材專著
