4 inch低位錯密度InP單晶的VGF生長及性質研究
發布時間：2018-12-13 17:38
【摘要】：采用高壓垂直溫度梯度凝固法(VGF)生長了非摻、摻硫和摻鐵的4 inch直徑(100)InP單晶,獲得的單晶的平均位錯密度均小于5000 cm~(-2)。對4 inch InP晶片上進行多點X-射線雙晶衍射測試,其(004)X-射線雙晶衍射峰的半峰寬約為30弧秒且分布均勻。與液封直拉法(LEC)相比,VGF-InP單晶生長過程的溫度梯度很低,導致其孿晶出現的幾率顯著增加。然而大量晶體生長結果表明VGF-InP晶錠上出現孿晶后,通常晶體的生長方向仍為(100)方向,這確保從生長的4 inch VGF-InP(100)晶錠上仍能獲得相當數量的2~4 inch(100)晶片。由于鐵在InP中的分凝系數很小,摻Fe-InP單晶VGF生長過程中容易出現組份過冷,導致多晶生長。通過控制生長溫度梯度及摻鐵量,可獲得較高的摻鐵InP單晶成晶率。對VGF-InP單晶的電學性質、位錯密度及位錯的分布特點、晶體完整性等進行了研究。
[Abstract]:The 4 inch diameter (100) InP single crystals without doping, sulfur and iron were grown by high pressure vertical temperature gradient solidification method (VGF). The average dislocation density was less than 5000 cm~ (-2). The multipoint X ray double crystal diffraction measurements on 4 inch InP wafer show that the half width of (004) X ray double crystal diffraction peak is about 30 arc seconds and the distribution is uniform. Compared with the liquid-sealed Czochralski (LEC) method, the temperature gradient in the growth process of VGF-InP single crystal is very low, which leads to a significant increase in the probability of twin appearance. However, a large number of crystal growth results show that after twins appear on VGF-InP ingot, the growth direction of the crystal is still (100) direction, which ensures that a considerable number of 2 inch (100) wafers can still be obtained from the grown 4 inch VGF-InP (100) ingot. Due to the small segregation coefficient of iron in InP, the component undercooling is easy to occur during the growth of Fe-InP doped single crystal VGF, which leads to polycrystalline growth. By controlling the growth temperature gradient and the amount of iron doped, a higher crystallinity of Fe-doped InP single crystal can be obtained. The electrical properties, dislocation density, dislocation distribution and crystal integrity of VGF-InP single crystals were investigated.
【作者單位】： 中國科學院半導體研究所中國科學院半導體材料科學重點實驗室低維半導體材料與器件北京市重點實驗室;中國科學院大學材料科學與光電技術學院;
【分類號】：TN304
，
本文編號：2376948
[Abstract]:The 4 inch diameter (100) InP single crystals without doping, sulfur and iron were grown by high pressure vertical temperature gradient solidification method (VGF). The average dislocation density was less than 5000 cm~ (-2). The multipoint X ray double crystal diffraction measurements on 4 inch InP wafer show that the half width of (004) X ray double crystal diffraction peak is about 30 arc seconds and the distribution is uniform. Compared with the liquid-sealed Czochralski (LEC) method, the temperature gradient in the growth process of VGF-InP single crystal is very low, which leads to a significant increase in the probability of twin appearance. However, a large number of crystal growth results show that after twins appear on VGF-InP ingot, the growth direction of the crystal is still (100) direction, which ensures that a considerable number of 2 inch (100) wafers can still be obtained from the grown 4 inch VGF-InP (100) ingot. Due to the small segregation coefficient of iron in InP, the component undercooling is easy to occur during the growth of Fe-InP doped single crystal VGF, which leads to polycrystalline growth. By controlling the growth temperature gradient and the amount of iron doped, a higher crystallinity of Fe-doped InP single crystal can be obtained. The electrical properties, dislocation density, dislocation distribution and crystal integrity of VGF-InP single crystals were investigated.
【作者單位】： 中國科學院半導體研究所中國科學院半導體材料科學重點實驗室低維半導體材料與器件北京市重點實驗室;中國科學院大學材料科學與光電技術學院;
【分類號】：TN304
，
本文編號：2376948
本文鏈接：http://lk138.cn/kejilunwen/dianzigongchenglunwen/2376948.html
最近更新
教材專著
