【摘要】：碳納米管涂層已在低溫工作環(huán)境中大量應用,所選用的粘結劑在很大程度上影響其紅外吸收性能及與基體的結合性能。分別用水玻璃粘結劑和磷酸鹽粘結劑與碳納米管、鎳粉混合制成涂料,并將其涂覆在銅基體表面。采用XRD和SEM對涂層的紅外吸收性能、物相、晶體結構及形貌進行了表征;測試了涂層的抗熱震性能。結果表明:當粘結劑為磷酸鹽、含量為90%~85%時,1 400~3 570 cm~(-1)(2.80~7.14μm)波段內涂層的平均光吸收度達1.992~2.084,紅外吸收性能最佳,抗熱震次數(shù)可達35次(25~120℃),滿足了用戶要求(10次)。
[Abstract]:Carbon nanotubes (CNTs) coatings have been widely used in low temperature working environment. The selected binder greatly affects the infrared absorption properties and the binding properties of CNTs to the substrate. The coating was prepared by mixing sodium silicate binder and phosphate binder with carbon nanotubes and nickel powder respectively and coated on the surface of copper substrate. The infrared absorption, phase, crystal structure and morphology of the coating were characterized by XRD and SEM, and the thermal shock resistance of the coating was tested. The results show that when the binder is phosphate and the content of the binder is 90 ~ 85, the average light absorption of the coating in the band of 1 400 ~ 3 570 cm ~ (-1) (2.80 ~ 7.14 渭 m) is 1.992m2.084, the infrared absorption is the best, the times of thermal shock resistance can reach 35 times (25120 鈩，

本文編號：2177536