本文關鍵詞： NiCuZn鐵氧體 磁導率 低溫?zé)Y(jié) 助熔劑 磁性能　出處：《電子科技大學》2014年碩士論文　論文類型：學位論文

【摘要】：為在低溫?zé)Y(jié)下得到性能優良的NiCuZn鐵氧體材料,本文在NiCuZn鐵氧體材料主配方確定的基礎上,進行助熔劑摻雜,分別進行了V2O5、Bi2O3、WO3單一摻雜以及Bi2O3-V2O5、Bi2O3-WO3復合摻雜,采用氧化物燒結法制備,調節工藝,進行適量摻雜,在13.56MHz制備出性能優良的低溫?zé)Y(jié)NiCuZn鐵氧體材料,同時,對比分析了不同助熔劑對于NiCuZn鐵氧體材料微觀結構及磁性能的影響。在理論方面,本文對NiCuZn鐵氧體的晶體結構、離子分布、超交換作用等基礎理論進行闡述,其次對NiCuZn鐵氧體的磁導率、截止頻率等重要磁參數進行了描述,最后針對NiCuZn鐵氧體燒結特性以及低溫?zé)Y(jié)的意義進行了分析與闡述。通過在二次球磨前分別加入V2O5、Bi2O3,實現了950℃下的低溫?zé)Y(jié),得到了性能良好的鐵氧體材料。加入不同含量的V2O5與Bi2O3,磁導率變化規律均為先升高后降低,這表明液相助燒機制可以降低燒結溫度,但是隨著助熔劑含量的繼續升高,反而產生了晶粒生長異常,氣泡增多,導致了性能下降。其中,加入Bi2O3得到了低溫?zé)Y(jié)高導低損的鐵氧體材料,加入V2O5得到了低溫?zé)Y(jié)高導高損的鐵氧體材料。隨后進行了WO3的摻雜,實驗結果表明,WO3的加入不能降低本實驗配方的樣品燒結溫度,對于晶粒生長有一定的抑制作用,材料樣品的磁導率實部虛部均有所降低,但對品質因數Q值有明顯的提高作用。結合單一摻雜助燒性能,進行了Bi2O3-V2O5、Bi2O3-WO3復合摻雜,結果表明,在摻雜Bi2O3含量不變的基礎上,進行V2O5的摻雜,會導致樣品磁導率實部虛部均有所升高,而在Bi2O3含量不變的基礎上加入WO3,樣品品質因數Q有所提高,但是磁導率明顯降低。為進一步改善產品性能,對球磨時間、預燒溫度和燒結溫度對材料性能的影響進行了分析研究。隨著球磨時間、預燒溫度和燒結溫度的增加,樣品的磁導率均呈現先升高后降低的變化規律。球磨時間升高使材料破碎越來越均勻細致,提高了燒結活性,但是之后性能的降低則是由于過久的球磨導致雜質鐵的引入,改變了配方結構。隨著預燒溫度升高,晶粒初步生長,晶格缺陷得以修正,但會降低燒結活性。而燒結溫度的過度升高,會引起晶粒異常生長,氣泡增多,反而不利于性能提高。
[Abstract]:In order to obtain NiCuZn ferrite materials with excellent properties under low temperature sintering, on the basis of the determination of the main formula of NiCuZn ferrite materials, the fluxes were doped, the single doping of V _ 2O _ 5 and Bi _ 2O _ 3O _ 3 and the composite doping of Bi _ 2O _ 3-V _ 2O _ 5 and Bi _ 2O _ 3-WO3 were prepared by oxide sintering method. The low temperature sintered NiCuZn ferrite materials with excellent properties were prepared by adjusting the process and doping at 13.56MHz. At the same time, the effects of different fluxes on the microstructure and magnetic properties of NiCuZn ferrite materials were compared and analyzed. In this paper, the basic theory of crystal structure, ion distribution and superexchange interaction of NiCuZn ferrite is described. Secondly, the important magnetic parameters such as permeability and cut-off frequency of NiCuZn ferrite are described. Finally, the sintering characteristics of NiCuZn ferrite and the significance of low temperature sintering are analyzed and expounded. By adding V _ 2O _ 5 and Bi _ 2O _ 3 respectively before secondary ball milling, the low temperature sintering at 950 鈩，

本文編號：1539839